New Astfin based PBX from Inoteska

By mark | Published: June 13, 2009

Inoteska Ltd, based in Liptovsky Hradok, Slovakia released today new Astfin powered IP-PBX design.
The board is capable of accepting various modules to provide digital and analog connectivity (PRI, BRI, FXS, and GSM).

Main Board

Inoteska-1

Full Press Release

Hardware

BLACKFIN processor BF527 600MHz
64MB RAM
128MB NAND Flash
8MB DATA Flash
Optional SD card
Power supply: 230V/50Hz or DC 48V
Dimensions: 160x233x27mm (heigth depends on used modules)

Interfaces

A variant (backplane) – 8 analog modules
0/32 analog interfaces
0/6 E&M interfaces
0/4 BRI interfaces S0 TE/NT with optional power supply 48V
1xE1 (future expansion possibility up to 2,3 + HW Echo Canceller, if without BRI)
1xUSB OTG
2xEthernet 10/100BT
1xRS232 console
0/4 GSM (future expansion up to 12)

B variant (backplane + extension board) – 16 analog modules
0/64 analog interfaces
0/12 E&M interfaces
0/8 BRI interfaces S0 TE/NT with optional power supply 48V
1xE1 (future expansion possibility up to 2,3 + HW Echo Canceller, if max 4xBRI)
1xUSB OTG
2xEthernet 10/100BT
1xRS232 console
0/4 GSM (future expansion up to 12)

The schematic is available as well ;)

This entry was posted in Hardware. Bookmark the permalink. Post a comment or leave a trackback: Trackback URL.

2 Comments

  1. AliBB
    Posted June 16, 2009 at 12:59 pm | Permalink

    Mark, this is again an exciting design. Are modules used are different from IP04/08 and FX08 ?

    Ali.

  2. mark
    Posted June 16, 2009 at 2:09 pm | Permalink

    Ali,
    All credits should go to Intoeska Ltd,. I just relayed the news ;)
    As far as I know, their modules are completely different.
    Mark

Post a Comment

You must be logged in to post a comment.